Sender/Gauge Corrector Module 12/24vdc
$410.40
The 410 063 has been designed to correct the problem that occurs when an original vehicle sender is not available to match a particular gauge and vise versa.
Description
Sender/Gauge Corrector Module 12/24vdc
PN: 410 063
GENERAL
The 410 063 has been designed to correct the problem that occurs when an original vehicle sender is not available to match a particular gauge and vise versa.
Another example is where the fuel level sender in an LPG tank needs to be used to accurately drive the original (petrol) fuel gauge in a vehicle. Alternately, the unit could be automatically switched in to circuit when the changing between petrol & gas.
It can also ‘copy’ the signal from an existing gauge/sender combination so that the fuel level may also be observed at a different location. In this case one sender can be used to drive three or four matching gauges.
Because the unit is effectively a ‘resistance converter’ it can also be used on temperature or pressure gauges to correct where the original sender is no longer available for a gauge.
A further advantage is the 8 point conversion curve built in to the unit. This allows it to be used where the resistance graph is a curve, as in large and irregular shaped fuel tanks on trucks and off-road vehicles.
Setting up is extremely simple and can be done on site with almost all applications. Alternately, the modules can be pre-programmed if neccessary to fit a particular application.
NOTES
This unit can only be used with resistive senders, not capacitive senders.
The unit will not work with bimetallic gauges using mechanical regulators as it needs a constant supply voltage.
The unit will not work if supply to it fails or the gauge or sender fails.
CONNECTIONS
Term no. 5 -Ignition +Ve
Term no. 6 -Ground
Term no.3 -Input Resistance/Gauge
Term no.4 -Output to Gauge
SPECIFICATIONS
Protection: IP52 Rated case – terminals to be pointing down to prevent ingress of water
Dimensions: 68 x 30 x 73mm deep, overall box dimensions
Mounting: Hole centers…83mm, Mounted Height…35mm. Box with plug & wiring allow 110+mm depth.
Voltage: 12/24vdc negative ground, 30mA typical quiescent current draw
Input: Resistive only. 0-12VDC or 0-24VDC (235 ohm pull up resistor included)
Output rating: Resistive only. 0-12VDC or 24VDC. (Pull up resistor not required)
